Circutor AFQm IP54 Serie Manual De Instrucciones página 157

AFQm IP54
Parameter
Temperature IGBT 4
Temperature IGBT 5
Temperature IGBT 6
Temperature Inductor 3
Temperature Inductor 4
Phase L1 - L2 voltage
Phase L2 - L3 voltage
Phase L3 - L1 voltage
Positive DC bus voltage
Negative DC bus voltage
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
(2)
Parameters only accessible for the 60A model.
(3)
Parameter
Current in the filter
Phase – neutral voltage
% of filter power used
Voltage THD
Parameter
AFQm IP54 serial no.
DSP software version
HMI software version
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
(4)
8.2.2.4.- AFQm IP54 filter messages
Parameter
Device status
For a system with devices in parallel, the parameter value is that of the device connected with RS-485.
(5)
Parameter
Alarm messages
Instruction Manual
Table 25 (Cont.): Modbus memory map: Filter parameters (Table 1).
Address
(2) (3)
(2) (3)
(2) (3)
(2) (3)
(2) (3)
Table 26: Modbus memory map: Filter parameters (Table 2).
L1 L2
A3 - A2 A5 - A4
AA AB
D8 D9
BA BB
Table 27: Modbus memory map: Filter parameters (Table 3).
Address
2710 - 2711
(4)
10C
1C3
Table 28: Modbus memory map: Filter messages (Table 1).
(5)
Bit
0x0001
0x0002
0x0004
Table 29: Modbus memory map: Filter messages (Table 2).
Bit
0x00000000
0x00000002
0x00000004
F5 ºC with 1 decimal
F6 ºC with 1 decimal
F7 ºC with 1 decimal
FB ºC with 1 decimal
FC ºC with 1 decimal
DE V with 1 decimal
DF V with 1 decimal
E0 V with 1 decimal
E1 V with 1 decimal
E2 V with 1 decimal
L3 LN
A7 - A6 A9 - A8
AC -
DA -
BC -
Description
Hi [10] + Low [11] serial no.
Address
110
Description
Stop
1: ON
Start
0: OFF
Reset alarms
Address
105 (Hi value), 106 (Low value)
Description
There are no alarms
L1 overcurrent alarm
L2 overcurrent alarm
Units
Units
[Hi] + [Low] A with 1 decimal
V with 1 decimal
%
% with 1 decimal
-
-
Status
157