Operation Instruction; Holding Readings; Switching Rel; Switching Frequency Or Duty - koban KP 2102 Manual Del Usuario

KP 2102
Digital clamp meter

Operation Instruction

Holding Readings

Press the "HOLD/B.L" button
to hold the readings while taking
measurement and the value on the
display will be held.
Press the "HOLD/B.L" button
again to release the reading hold
function.

Switching Rel

REL key is the relative value
measurement communication
transmission key that acts with
trigger. Press this key will enter into
the relative value measurement
mode. The system will save the
display value in the memory as the
reference value.
When doing the measurement
later, the display value will be the
difference value that the entry value
deducts the reference value.
Press REL ▲ key will enter into
the Manual Measurement Mode
automatically.
In REL ▲ measurement status, press
the key again, the REL ▲ function will
be relocked.
Press the key in HOLD status, HOLD
function will be cancelled. The
Instructions manual | 34
system will save the display value in
the memory as the reference value.
When doing the measurement later,
the display value is the difference
that the entry value deducts the
reference value.
Press SELECT Key or use Mode Switch
will cancel REL ▲ measurement
mode, and go back to the normal
mode (REL ▲ will disappear in the
LCD).
OL triggering: Under REL ▲ mode,
OL shows when input value larger
than the allowed value of the
measurement mode. Press the key
again, the relative measurement
function will be cancelled.
Disable to enter REL ▲ mode when
OL shows.
No analog section bar function
under REL ▲ mode.
Switching Frequency Or
Duty
During working at the voltage or
current ranges, press the "Hz/%"
button one time, frequency of the
voltage or current will be measured.
Press the"Hz/%" button twice, the
meter will be changed into the duty
range for measuring the duty cycle
of the voltage or current. At the
same time, the meter is changed into
www.grupotemper.com