Programming New Program Lines (New) - ProMinent gamma/ L Instrucciones Suplementarias De Funcionamiento

Action Description
MAN Switch to MANUAL operating mode
BATCH* Switch to BATCH operating mode
CNTCT* Switch to CNTCT operating mode
ANALG* Switch to ANALG operating mode
FREQ Change the stroke rate
REL. x** Relay x triggered
V: xx Enable decelerator no. xx
Tab. 2: Actions and specifications
* option ** option; the timer must be configured (see section 3)
TIME
ProMinent ®
2.1

Programming new program lines (NEW)

NOTICE
You cannot set up or program the pump in TIMER mode ("Auto").
Therefore select another operating mode.
A program line is basically structured as follows (with example):
Event to be enabled
CNTCT
Event to be enabled tells you what the effect of action will be.
Action tells you what type of action should take place at the time of the event to be enabled.
Specification gives you the precise description of the action.
The example means:
that when a contact is applied to the external contact input the pump should run at a predetermined stroke
rate - at 120 strokes/min.
Event to be enabled
TIME
CNTCT
AUX
Vxx
Tab. 1: Events to be enabled
Note
also available in "simple" timer mode
Do not program when enabling
CNTCT event!
Do not program when enabling
CNTCT event!
does not alter the operating mode
see "Settings for relay function
Further details see below
If enabling both TIME and Vxx (Decelerator) events, program lines include two other components::
The TIME event to be enabled activates actions periodically. A program line with TIME therefore has "Cycle"
and "Switching time" components.
Event to be enabled
TIME
* does not apply to timer type "simpl"
IMPORTANT
When displaying the program lines, the timer program combines the "Cycle" and "Switch time"
elements and gives precedence to the switching time (note also the type sequence, see 2.2).
The program lines for the above example would look like this:
Settings for the "Timer" function (SET-menu)
Action
FREQ.
Description
Switching time reached
External contact -
circuit made
(min. 20 mS)
Auxiliary contact -
circuit made
Delay time of
Decelerator no. xx
expired
*** stroke rate "0" means "pump stop"
Cycle Switching time
DAILY 15:23
Specification
120
Note
Further details see below;
also available in "simple"
timer mode
Do not program CNTCT
and BATCH actions!
The auxiliary frequency must
be set in the Set-menu to "0"!!
Specification (description)
00 ... f ***
max
Stroke rate
0001 ... 32767
Batch size
00.01 ... 99.99
Factor
---
00 ... f ***
max
Stroke rate
ON, OFF
"Switch status of the timer
(note section 3!)
---
Action* Specification
CNTACT 00050
25