After Use; Cleaning And Maintenance; Safety Information - CASO DESIGN 1848 Manual De Instrucciones

The device will brew coffee until the water tank is empty. Then you can hear one acustic
signal and the start button is illuminated without flashing. The device will automatically
enter into keep-warm mode and will switch off automatically after 30 minutes. You can
hear an acoustic signal.
This device is equipped with a drip stop system which enables you to serve coffee before
all the water has dripped through. Quickly put the jug back in place to avoid any spillage.
► Use only cold water.
► Do not exceed the maximum amount of water indicated on the scale of water tank.
► For better heat retention, rinse out the jug with hot water before use.
► Wait a few minutes before brewing coffee again.
► The device will keep the coffee warm 30 minutes after brewing and after this
automatically switches off.

13.5 After use

Pull the plug and wait until device is cooled down. Remove the jug from the warming plate.
Clean grinding/brewing container, round filterinsert, filter, lid of grinding/brewing container
and the jug, please refer to "cleaning and maintenance".

14 Cleaning and Maintenance

This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.

14.1 Safety information

Attention
Please observe the following safety notices, before you commence with cleaning the
device:
► The device must be cleaned at regular intervals and limescale should be removed.
► Switch the device off prior to cleaning it and unplug the plug from the wall power outlet.
► The water tank, filter, jug and grinding/brewing container are hot after their use. Wait
until the device has cooled down.
► Do not use any aggressive or abrasive cleaning agents or solvents.
► Do not scrape off stubborn dirt with hard items.
Please note
53