Filter Cleaning; Surface Cleaning - Dimplex BOF4056 Manual Del Propietário

Maintenance
be changed.
3. Turn the unit off, and unplug
the engine.
4. Leave the appliance for 20
minutes to allow the lamps to
cool down before removing
them.
5. Remove the water tank and
sump (Figure 9) by lifting up-
wards and placing to the side.
6. Remove the defective bulb,
by gently lifting vertically and
disengaging the pins from the
lamp holder.
! NOTE: Replacement light
bulbs can be obtained by contact-
ing Dimplex Customer Service at
1-888-346-7539.
7. Carefully insert the two pins
of the new bulb into the two
holes in the lamp holder.
Push lamp firmly in place.
8. Replace the top cover, refill
container and log media.
Cleaning
It is recommended that all of the
components that contain water
are cleaned with soap and water
on a biweekly basis. A small
brush has been included to assist
in cleaning difficult items/areas,
i.e. the transducer.
16
Figure 9
Sump
Filter
CAUTION: Do not put plastic
components in the dishwasher.

Filter Cleaning

The air filter can be removed
and gently rinsed with water to
clean and dried on a towel before
reinstalling.
! NOTE: Replace the filter so
that the course black filter is fac-
ing the front of the engine.

Surface Cleaning

Use a warm damp cloth only to
clean surfaces of the engine. Do
not use abrasive cleaners.
!
NOTE: If you need to move
the unit ensure that all of the com-
ponents that contain water have
been emptied before relocating.
www.dimplex.com