Assembly - Dimplex BOF4056 Manual Del Propietário

Assembly

1. Carefully unpack all of the
components from the box.
(Figure 5)
2. Remove top cover by turning
the retaining tabs on both
ends of the water reservoir.
(Figure 6)
3. Install the light bulbs by
aligning the pins on the bulbs
and the fixture and pressing
down until they are fully
inserted. (Figure 7)
4. Install the transducer so that
it is sitting level in the circular
holding area in the reservoir.
! NOTE: The transducer is
packed in the water reservoir and
Figure 5
Removable Refill
Container
Light
Bulbs
Log
Media
10
Figure 6
Remote
Control
Top
Cover
Retaining
Tabs
wrapped to protect it during ship-
ping.
5. Orient transducer wire so that
it does not sit directly above
the emitter and the wire
passes through the slot in the
side of the tank. (Figure 6)
6. Reinstall the top cover and
ensure both retaining tabs
have been turned so that they
are pointing inwards.
7. Fill and install the Refill
Container.
! NOTE: Normal tap water can
be used in the Optimyst
as the tap water is not considered
to be hard water. In the event
Water
Reservoir
as long
®
Transducer
Emitter
Wire Slot
www.dimplex.com