Thermostat Installation Instructions - L.B.White Guardian AB250 Manual Del Usuario E Instrucciones

Thermostat Installation
(Must be ordered separately)
WARNING
Electrical Shock Hazard
■ Disconnect the electrical supply before
connecting the thermostat to the heater.
■ Failure to follow this warning can result in
electrical shock, leading to personal injury
or death.
1. To Connect the Series Tap Plug
Thermostat Kit:
a. Connect the power cord of the heater to the
female side of the plug on the end of the kit's
thermostat cord.
b. Plug the male side of the series tap plug
on the thermostat cord into a three-wire
(grounded) electrical outlet within the building.
2. To Connect the Direct Wired
Thermostat Kit to the Heater:
a. The installation and wiring of a thermostat
must be done by an electrician or someone
properly qualified.
b. The thermostat wiring shall use a minimum 18
gauge, 2 wire with ground.
c. The heater must be tested for proper operation
after the thermostat has been connected.
d. Refer to the Figs. 6-11 for thermostat connec-
tion.
FIG. 6
REMOVE HOLE PLUG NEAR POWER CORD
Guardian LP or Natural Gas Heater
FIG. 7
REMOVE ELECTRICAL ENCLOSURE COVER
FIG. 8
ROUTE POWER CORD
THROUGH BUSHING IN
ENCLOSURE
FIG. 9
SECURE POWER
CORD AT CASE WITH
APPROPRIATE
BUSHING
FIG. 10
REMOVE
JUMPER
Owner's Manual • Guardian
13