Preparing The Truck For Operation With An Additional Access Code - Jungheinrich EKS 314 Manual De Instrucciones

o Preparing the truck for operation with an additional access code
2.3
– Attach the belt system
(see section "Attaching the safety restraint belt" in this chapter).
– Close the safety gates securely on both sides.
– Turn the EMERGENCY DISCONNECT switch (5) to release it.
– Put the key in the key switch (3) and turn it clockwise.
– In the display unit (7) you are required to enter a 5 digit code / pin via the five func-
tion buttons (6)
NOTICE Press function key F0 (8) to assign to the five function keys (6) the digits 0 -
4 or 5 -9 for entering the code/pin.
NOTICE Unless the correct code/pin is entered, none of the truck's functions will
operate
NOTICE A maximum of 10 different code/pins can be set.
– Test the warning device (horn) (4).
– Test the operating and parking brakes.
– Carry out a test movement on the lift mast to adjust the height display.
NOTICE After a factory-set interval, you will be required to enter in the display a 5 digit
code / pin using the five function buttons (6).
Qw W
Press the EMERGENCY DISCONNECT switch (5) immediately if the truck
starts to move or lift when it is switched on.
NOTICE Brief steering movements caused by steering referencing are permissible.
E 10
7
8
6
5 4 3