Recommissioning The Truck After Cleaning Or Maintenance Work; Decommissioning The Industrial Truck; Operations To Be Performed Prior To Decommissioning - Jungheinrich EKS 314 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

6.8

Recommissioning the truck after cleaning or maintenance work

Recommissioning of the truck following the performance of cleaning or maintenance
work is permitted only after the following operations have been performed:
– Check the horn for proper functioning.
– Check the MASTER switch / EMERGENCY switch for proper functioning.
– Check the brake for correct functioning.
– Grease the truck in accordance with the lubrication schedule.
7

Decommissioning the industrial truck

If the industrial truck is to be decommissioned for more than one month (e.g. due to
internal reasons), it must be parked in a frost-free and dry location and all measures
to be taken before, during and following decommissioning must be performed as de-
tailed below.
IMPORTANT During decommissioning, the industrial truck must be jacked up, ensuring
that the wheels are clear of the ground. Only this measure will ensure that
wheels and wheel bearings do not suffer damage.
If the industrial truck is to be decommissioned for more than 6 months, additional
measures must be discussed with the Service Department of the manufacturer.
7.1

Operations to be performed prior to decommissioning

– Thoroughly clean the fork lift truck.
– Check the brakes for correct function.
– Check the hydraulic oil level and top up if required
(see section "Hydraulic oil" in chapter G).
– Apply a thin film of oil or grease to all parts not protected by a paint coating.
– Lubricate the fork lift truck according to the lubrication chart
(see section "Lubrication schedule" in chapter G).
– Recharge the battery (see section "Charge the battery" in chapter F).
– Disconnect and clean the battery. Apply pole grease to the battery poles.
NOTICE
In addition to this, all instructions given by the battery supplier must be
observed.
– Spray all exposed electrical contacts with a suitable contact spray.
G 16

Capítulos

Tabla de contenido
loading

Tabla de contenido