Tabla de contenido
5
4
6
Inset A
Inset B
10---
_
11--
12-'--'--
13 _
14-'"
1. Outer side shield
2.
Nut'A"
3.
Nut"B"
4.
Drive control bar
5.
Handle
6. Throttle control
7.
Shift lover indicator
3
3
Rgure 10
Reverse
a. Release thedrivecontrolher (fig.'10).
b. Movethrottlecontrol(fig.10) to "SLOW"speed
c.
Place shift lever indicator (fig. 11 -inset A) in the "R"
(reverse)pos_on.
d. Do not standdirectlybehindfiller.
e. Hold the drivecontrol bar againstthe handle (fig. 10) to
starttillermovement.Tineswill not turn.
WARNING!
Don1 back yourself into a solid obstruction such as a tree,
fence, etc.
7
Figure 11
Stopping
tines and engine
a.
TiUermovement and fines will stop when drive control bar
(fig. 10) is released.
b.
Move shift lever indicator (fig. 11 -inset A) to "N" (Neutral)
position.
c. To stop engine, move throttle control (fig. 10) to "STOP"
position.
Tuming
a.
Releaso the drive controlbar (fig. 10).
b.
Move throttle control (fig. 10) to "SLOW" position.
c.
Place shift lever indicator (fig. 11 - inset A) in "P (forward)
po6ition. Tines will not turn.
d.
Lift handle to raise tines out of the ground (fig. 10)
e.
Swinc,:,_ the handle in the opposite direction you wish to
turn, being careful to keep feel and legs away from the
tines.
When you have completed your turn-around, lower the handle.
Place shift lever indicator in ='1" (tilling) position and move
throttle control to desired speed. To begin tilling, hold drive
control bar against the handle.
16
Inset C
Outer side shields
The back of the outer side shields (fig. 10) are slotted so that
they can be raised for deep tilling and lowered for shallow
filling to protect small plants from being buried. Loosen nut
"A"in slot and nut "B". Move shield to desired position (both
sides). Retighten nuts.
10. Transport position
11. Shallowest tilling
12. Shallow tilling
13. Deep tilling
14. Deepest tilling
15. Depth stake
Transporting
a.
Lower the depth stake to its lowest position and insert
the depth stake pin in the topmost hole.
b.
Place shift lever indicator (fig. 11 inset A) in "F" (foward)
position for transporting.
c.
Hold the drive control bar against the handle (fig. 10) to
start tiller movement. Tines will not turn.
d.
Move throttle control (fig. 10) to desired speed.
16. "Release" position
17. "Lock"position
8.
Depth stake
9.
Depth Stake pin
23
Tabla de contenido
