OPERATIONAL INSTRUCTION
The next step will show the total distance (accumulated distance)
on the DISTANCE window (WINDOW 1). Press START / ENTER (KEY
10) to select the next parameter.
The next step will show the total time (accumulated hours) on the
TIME window (WINDOW 2).
Press START / ENTER (KEY 10) and select the next parameter.
The next step will display the firmware version in the DISTANCE
window (WINDOW 1). Press START / ENTER (KEY 10)
to end.
GENERAL
Press START / ENTER (KEY 11) to stop. Press STOP / RESET (KEY 11) twice to reset the
system.
Before starting, the control panel counts down to 3 seconds and 3 tones in the alarm.
Under the condition of adjustment, there is no operation for 15 seconds, the
equipment will exit configuration mode.
Each key has a beep.
After 5 seconds, if there is no speed sensor signal, the treadmill will stop.
When the emergency button is held down, the entire display shows "E" and blinks.
TOTAL TIME AND DISTANCE:
Total time: 9999 hours -> 0001 = 1 hour
Total distance: 9999 km x 10 -> 0001 = 10 km
40
/
/
TIME
TIME
TIME