INSTRUCTIONS FOR THE INSTALLER
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL
EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE,
ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS.
INSTALLATION
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 75°C besides the room one.
The equipment must not be installed near
inflammable materials, such as curtains, cloths,etc.
Make an opening in the worktop of the dimensions
indicated in fig. 3 respecting a distance from the
edges of the appliance of at least 100mm from the
side walls and 50 mm from the rear wall.
MODEL
7038632
7039632
7040632
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving a
depression space of at least 10 mm (fig. 4).
If the hob is going to be installed on the top of an
oven, precautions must be taken to guarantee an
installation in accordance with current accident
prevention standards. Pay particular attention to
the position of the electric cable and gas pipe: they
must not touch any hot parts of the oven.
Moreover, if the hob is going to be installed on
the top of a built in oven without forced cooling
ventilation, proper air vents must be installed to
guarantee an adequate ventilation, with the lower
air entering with a cross section of at least 200cm
and the higher air exiting with a cross section of at
least 60 cm
.
2
IMPORTANT NOTICE:
L (mm)
P (mm)
560
480
700
480
860
480
Fastening the top
Every cook-top is equipped with a special washer.
A set of hooks is also supplied for mounting the
cook-top.
Depending on the type of mounting surface, the
suitable type of mounting hook is supplied.
For the installation proceed as follows:
- Remove the racks and burners from the top.
- Turn the appliance upside down and lay the
washer S along the edge of the glass (fig. 5).
- Introduce and place the cook-top in the hole made
in the piece of furniture, then block it with the V
screws of the fastening hooks G (fig.6).
Installation room
This appliance is not provided with a device for
exhausting the products of combustion.
Regarding room ventilation rules where appliance
is installed make reference to the legislation, in
conformity with the local regulations.
Gas connection
Make sure the appliance is prepared for the type
of gas available, see the label under the appliance.
Operate according to the instructions given in the
paragraph "gas transformations and regulations"
for possible adaptation to different gases.
The appliance must be connected to the gas
system using rigid metal pipes conforming to the
current standard or with continuous wall steel flex-
ible pipes complying with the current standard.
Some models come with two fittings:
one cylindrical A, one conical B (fig 7).
Choose the appropriate fitting according to the
country of installation.
The connection must not cause strain on the gas
train.
,
2
After installation, check the tightness of the
connections with a soapy solution.
11