Starting And Ending Configuration Mode; Menu Level 1: Set Temperature - Dometic Waeco CoolAir RT 880 Instrucciones De Instalación

Installation
7.3.1

Starting and ending configuration mode

The adjustable parameters can be changed in configuration mode:
➤ When using the ON/OFF (fig. b 1,page 10) button to switch on the
unit, hold both buttons + and – (fig. b 6 and 7, page 10) pressed until
the compressor LED flashes.
✓ You are now in configuration mode.
✓ The display version (e. g. "3.1S") appears in the digital display
(fig. b 5,page 10) for 2 seconds.
✓ The first digit of the digital display (fig. b 5,page 10) shows the menu
level and the second and third digits show the parameters which can
be set, e.g.
I
NOTE
If you make no entry on the control panel for 60 seconds, the unit quits
configuration mode and shuts down.
➤ Press the ON/OFF button to quit configuration mode.
7.3.2

Menu level 1: Set temperature

The unit always starts with a defined value for the room temperature. This
parameter can be configured between 17 and 30 °C (62 and 86 °F).
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 48).
✓ The first digit of the display (fig. b 5,page 10) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the Operating Mode button (fig. b 4,page 10) to change the
parameters.
➤ Use the + and – buttons (fig. b 6 and 7, page 10) to select the target
value (in °C) at which the unit should start operation.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Press the Operating Mode button (fig. b 4,page 10) to confirm your
entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 1 again and can use the + and – buttons to
switch between menu levels.
48
for menu level 1 and a set target value of 17 °C.
1.17
CoolAir RT880, SP950T
EN