Ground Connection - ESAB Origo Arc 250 edw Manual Do Usuário

4.2.3 Ground connection

The ground terminal is connected to the chassi of the machine. It should be connected to
a efficient ground point of the main power installation.
Do not use the neutral of main power installation.
4.3 Engine lubricant
The engine is shipped with oil. Check the level before start. Use a 4-stroke, high
detergent, premium quality motor oil certified to meet or exceed U.S. automobile
manufacturer's requirements for service classification SG, SF. Refer to the engine
manual for recommended viscosities. lf multi viscosity oil is used, select the
appropriate víscosity for the average temperature in your area.
OIL
FILTER
CAP
DIPSTICK
ATTENTION: Engine with oil alert device
The Oil Alert System is designed to prevent engine damage caused by an insufficient
amount of oil in the crankcase. Before the oil level in the crankcase can fall
below a safe limit, the Oil Alert System will automatically stop the engine (the engine
switch will remain in the ON position). If the engine stops and will not restart, check the
engine oil level.
4.4 Battery.
The machine is shipped without battery. Must be purchased separately by the customer
in accordance with the following specifications: Voltage: 12 VDC, 45Ah, maximum
dimensions: Height: 170 mm,
Install the battery in this compartment and connect the positive cable (red) first and
negative cable (black) after.
4.5 Air filter.
Check that the dry air filter is correctly installed and that there is no air leakage
around the filter which could let unfiltered air into the engine.
The level should be between the
references of maximum and
minimum. If necessary, refill.
UPPER LIMIT
LOWER LIMIT
Width: 170 mm, Length: 240 mm.
- 28 -