Technical Data; Noise Information - Hilti DX 9–HSN Manual De Instrucciones

4

Technical data

4.1 Technical data
Weight
Dimensions (L × W × H)
Magazine capacity
Suitable cartridges
Suitable fasteners
Fastener driving rate
Thickness of the supporting steel
Compression stroke
Contact pressure
Application temperature (ambient temperature)
4.2

Noise information

The noise values listed were determined under the following conditions:
General conditions for noise measurements
Direct fastening tool
Model
Caliber
Power setting
Application
Noise information in accordance with EN 15895
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound (power) level (L
WA
Uncertainty for the sound power level (K
Peak sound pressure emission level (L
Uncertainty for the peak sound pressure level (K
4.3 Vibration
The vibration value that must be specified in accordance with 2006/42/EC does not exceed 2,5 m/s².
5 Operation
5.1 Preparations at the workplace
5.1.1 Establishing the position of the fasteners
To avoid incorrectly driven fasteners, proceed as follows:
*2194029*
)
pA
)
pA
)
)
WA
)
pC, peak
2194029
DX 9–HSN
28.4 lb
(12.9 kg)
39.3 in × 14.4 in × 6.9 in
(999 mm × 365 mm × 175 mm)
60 nails / 40 cartridges
6.8/11 M40 red or other car-
tridges of a type approved for
use with the tool
X­HSN 24
0.333 Hz
(1,200 rev/h)
1/8 ... 3/8"
3.20 in
(81.3 mm)
≥ 56 lb
(≥ 250 N)
5 ℉ ... 122 ℉
(−15 ℃ ... 50 ℃)
DX 9–HSN
Series
6.8/11 red
4
Fastening to steel plate (Brinell
hardness 358 N/mm
X–HSN 24
98 dB(A)
2 dB(A)
106 dB(A)
2 dB(A)
131 dB(C)
) 2 dB(C)
pCpeak
f
) using the
2
English 7