Motor Protection; Operation - Wilo TOP-S Instrucciones De Instalación Y Funcionamiento

5.2.1 Motor protection

Pump with terminal box type
(P
TOP-
(330 W ≤ P
S/SD/Z
1~230 V
(650 W ≤ P
TOP-
S/SD/Z
3~400 V
(320 W ≤ P
TOP-D
(100 W ≤ P
– When setting the thermal tripping mechanism,
where available, observe the corresponding ma-
ximum current (see rating plate) of the speed le-
vel at which the pump is run.
Internal switch off of
the motor mains
1
max ≤ 245 W)
1
WSK and external
2
SK622, C-SK or
max ≤ 400 W)
1
other control unit)
3
disconnection by
integrated electrical
max ≤ 1030 W)
1
4
disconnection of
max ≤ 245 W)
(P
one motor phase
1
5
disconnection by
integrated electrical
max ≤ 1685 W)
1
6
max ≤ 90 W)
(P
1
WSK and external
7
switch box (SK602 /
max ≤ 245 W)
1
other control unit)
Tripping
power supply
switch (SK602 /
All-pole
simultaneous to the
trip relay
Internal
All-pole
simultaneous to the
trip relay
–
SK622, C-SK or

6 Operation

6.1 System filling and venting
The system must be filled and vented properly. The
pump rotor chamber will vent automatically after a
short running period. Brief dry running will not
damage the pump. The TOP-S/-SD/-Z pumps and
TOP-D pump which are equipped with vent screws
can be ventilated as follows if necessary:
SSM
–
–
Tripping of SSM
tripping of the
integrated overload
trip relay
–
Tripping of SSM
tripping of the
integrated overload
trip relay
–
–
ENGLISH
Reset
Auto-reset - once
the motor has
cooled down the
pump will automati-
cally switch back on
Manually at the
external switch box
once the motor has
cooled down
Manually at
the pump
once the motor
has cooled down
– disconnect the
voltage supply
– motor has cooled
down
– switch the voltage
supply back on
Manually at
the pump
once the motor
has cooled down
–
Manually at the
external switch box
once the motor has
cooled down
25