Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Throghout the use of the shredder situations and or problems may occur, for which we present some
suggestions:
Trouble
Probable Cause
Shredder
Excessive intake/feeding. Due to
jamming
this the motor can not maintain
necessary rotation, and the material
accumulates inside the shredder.
Use under this condition may cause
motor to overload.
Low production
Insufficient feeding of shredder.
Irregular cut
1. Cutting blades need
2. Counter cutting blade worn or
3. Insufficient feeding of cylinder
Trouble starting
1. Excessive intake of product in
motor
2. Electrical shortage.
TRAPP Symbols for Animal Ration Shredder
Attention!
Warning.
Read operator's manual.
Utilice guantes para protección.
Useful Suggestions
sharpening.
not regulated properly.
feeder.
shredder.
Solution
Turn off shredder and wait for motor to come to
a full stop. Open the lid, remove excess material,
close lid, turn on shredder, wait for motor to
reach maximum rotation and restart work. Control
intake/feeding according to motor's capacity.
Maintain a continuous feeding flow, yet not over-
feeding which may cause the shredder to jam.
1. Sharpen cutting blades as indicated in
Maintenance (page 32).
2. Proceed as indicated on page 32
Maintenance of Counter Cutting Blade.
3. Increase the tension of cylinder spring (see
page 30). Substitute upper cylinder if worn.
1. Once work is finished, always leave shredder
working for a few extract minutes to allow all
material to exit.
2. Check condition of electrical power source.
Wear protection goggles and ear
protection.
Attention.
Keep hands and feet away.
Ground Conection.
33
Tabla de contenido
