Main Components - TRAPP ES-400 Manual De Instrucciones

1. Green funnel
2. Belt protection
3. Upper exit
4. Motor
5. On-off switch
8
3
9
All TRAPP shredders, single-phase or three-phase,
are assembled with double voltage motors.
They leave factory without electrical connection
to allow the customer to choose the kind of
connection based on the voltage of their property
power source.
To correctly make the connection, see data shown
on the motor plate and the number printed on the
insulation of the wires.
For shredders sold without motor, the choice of
minimum output shall follow the technical data
shown on pg. 29.
28

Main Components

6 7
5
Motor Installation
6. Hatch cover
7. Transmission box
8. Cylinder feeders
9. Base/support
10. Rubber cushion
1
Attention!
Before making any connections, make sure
power source is disconnected.
1. Make sure the power source where the
shredder will be installed is compatible with
the data shown on the motor plate.
2. Disconnect the power source to make motor
connections.
3. Make the connections shown according to
the voltage of the power source.
4. Use insulating tape in the connections done
to protect them.
5. Make sure the connections are well insulated.
6. Turn on power source and check the rotation
of the shredder.
7. Ground the equipment.
www.trapp.com.br
2
4
10