TRAPP ES-400 Manual De Instrucciones página 30

The 5 mm or 10 mm length of cut is obtained by
changing the position of the belt (fig. a). To change
the belt, do as follows:
1. Remove the belt protection (fig. a).
2. Loosen the fixation screws of the reduction box
(fig. b 1), and the belt stretching screw (fig. b 2).
3. Place the belt in the position of the cut length
you prefer (fig. c).
4. Stretch and align the reduction box belt using the
screw (fig. b 2).
5. Tighten the reduction box fixation screws
(fig. b 1).
6. Replace the belt protection (fig. a).
Fig. a
If the pressure of the cylinder feeder is insufficient,
the material will not be pulled evenly, in this case:
1. Remove the springs (1).
2. Remove the axle which positions springs (2)
and replace it the upper hole.
Note:
When the springs no longer have sufficient
tension, they should be replaced.
30
Length of Cut
Belt protection
Pressure of the Cylinder Feeder
2
Fig. b
Adjusting length of cut
Cutting disk pulley
Fig. c
Fig. c
1
www.trapp.com.br
1
5 mm
Box pulley
10 mm
2 1