Fig. 4: Minimum Distances On Mounting The In40-E0109K Safety Switch - SICK IN4000 Direct Manual Del Usuario

en
Chapter 4
Fig. 4: Minimum
distances on
mounting the
IN40-E0109K
safety switch
70
Mounting
• The safety switch must be mounted such that the
sensing face is orientated towards the moving part
of the guard (door or similar). The sensing face can
be aligned if required.
• The safety switch is supplied pre-assembled on a
mounting bracket. It is not necessary to dismantle
the mounting bracket to align the sensing face on
the sensor.
Align the sensing face on the safety switch such that it
is orientated towards the moving part of the guard.
How to align the safety switch:
⋅ Undo the hex socket head screw on the sensor
bracket and pull the sensor off the bracket
(cf. Fig. 5 a-b).
⋅ Undo the two screws on the bottom corner of the
sensor housing and rotate the sensing face on the
sensor to the correct position (cf. Fig. 5 c-d).
⋅ Refit the sensor housing and refit the sensor to the
sensor bracket (cf. Fig. 5 e-f).
© SICK AG • Germany • All rights reserved
Operating instructions
IN4000 Direct
8012183/ZWH0/2018-06-05
Subject to change without notice