Panasonic ES‑LT7N Manual De Instrucciones página 23

Problem
The shaving sensor
responds even though the
shaver is not in contact
with the skin.
►When the STATUS lamp of the self-cleaning
recharger glows
It will light up for approximately 5 seconds every time the SELECT
button is pressed.
Problem
Pour new water
It is time to replace and detergent into
the cleaning liquid. the cleaning liquid
unit.
The cleaning liquid
Properly attach the
unit is not properly
cleaning liquid unit.
attached.
Place the self‑
The self‑cleaning cleaning recharger
recharger is tilted. on a horizontal
surface.
ES-LT7N_US.indb 23
Action
Clean the beard trimmings from
the shaver.
When the shaver is extremely
dirty, remove the foil frame and
wash with water.
(See page 17.)
Replace the system outer foil and/
or inner blades.
Expected life of system outer foil
and inner blades:
System outer foil:
Approximately 1 year
Inner blades:
Approximately 2 years
Action
The "AUTO"
mode cannot be
used. The
"Charge" and
"Dry/Charge"
modes can be
used.
Problem Action
Use the self‑ Use the self‑
cleaning recharger cleaning recharger
outside the range of in temperature
the recommended 15 °C (59 °F) or
usage temperature. higher.
After performing the above operation, press the SELECT button
and select a mode.
►When all self-cleaning recharger's lamps blink
Problem
Contact an authorized service
Appliance failure
center.
FAQ
Question
The drying time for the "Dry/
Charge" mode is set longer as
there may still be excess moisture
on the grip or areas other than the
system outer foil after the shaver
Why does "Dry/Charge"
has been rinsed and cleaned with
mode take longer than
water.
"AUTO" mode?
On the other hand, the drying
time for the "AUTO" mode is
shorter since only the system
outer foil is wet, which reduces
the total time for the whole mode.
Only "Charge"
mode can be
used.
Action
Answer
23
2015/04/17 17:45:29