Panasonic ES‑LT7N Manual De Instrucciones página 17

5
5
Remove the adaptor after the selected mode is
completed.
Mode
Charge
1 Charge
0 to 60 min
Clean
2 AUTO
10 min
• It is not possible to change the mode after the
"AUTO" mode has started.
Dry
3 Dry/Charge
180 min
• It is possible to change to the "AUTO" mode
even after the "Dry/Charge" mode has started.
• The drying time may increase in an ambient temperature
approximately 15 °C (59 °F) or lower.
The Clean or Dry function may not operate under extreme low
temperatures (approximately 0 °C (32 °F) or lower).
ES-LT7N_US.indb 17
Time required (guide)
Dry Charge
80 min 0 to 60 min
Charge
0 to 60 min
Cleaning the shaver without the self-cleaning recharger
Do not use kitchen, bathroom, or toilet detergents. Also, do not
wipe with thinners, benzine, alcohol etc.
Doing so may result in malfunction.
1. Turn the power switch OFF, and disconnect the AC adaptor.
• Unlock the switch lock.
2. Apply some hand soap and some water to the system outer foil.
3. Press the power switch for more than
2 seconds to activate the sonic vibration
cleaning mode.
• The battery capacity lamps blink in order.
• After about 20 seconds, it will be
automatically turned off.
4. Remove the outer foil section and press
the power switch for more than
2 seconds to activate the sonic vibration
cleaning mode.
5. Clean the shaver, the outer foil section,
and the trimmer with running water.
• After rinsing with water, shake the
shaver up and down for a few times to
remove excess moisture.
Hitting the vanity, etc., while shaking the shaver may cause malfunction.
• Splashing is reduced by rinsing the shaver in sonic vibration
cleaning mode.
6. Wipe off any drops of water with a dry cloth.
7. Dry the outer foil section, the shaver, and
the trimmer completely.
8. Attach the outer foil section to the shaver.
17
2015/04/17 17:45:29