Dometic CoolAir RT 780 Instrucciones De Instalación página 16

Installation
 You can connect the unit to the battery via the lorry's terminal block or
directly. The terminal block is to be preferred for the connection. On
some vehicles, larger consumers connected to the terminal block are
switched off after a short while if the power requirement is too high.
Ask your vehicle manufacturer for the specifications of the terminal
block.
 When installing the system and making the electrical connections,
observe the guidelines from the body manufacturer.
 Pay attention to the connection plan for the device:
No. in fig. 0,
page 8
!
WARNING!
Before installing the air conditioning roof unit, all connections to the
battery of the vehicle must be disconnected.
Non-observance of this regulation can result in danger of electrocution.
!
CAUTION!
Improper installation of the air conditioning roof unit can result in irrepa-
rable damage to the device and put the safety of the user at risk.
The manufacturer will not be held liable for claims if the air conditioning
roof unit is not installed according to this installation manual. That
applies to malfunctions and the safety of the air conditioning roof unit, in
particular to injuries and damage to property.
I
NOTE
After installing the unit, the specified parameters of the unit software
must be checked (chapter "Configuration of unit software" on page 20).
16
Designation
1 Control pad
2 Connection cable
3 Room temperature sensor
4 Earth
5 Klickson (compressor)
6 Compressor
7 Condenser fan
8 Vaporiser fan
9 Earth
10 25 A fuse
11 2 A fuse
12 4 A fuse
CoolAir RT780
EN