Denon 5900 Instrucciones De Operación página 12

ENGLISH
(3) Connecting to a AV amplifier with a built-in decoder
When DVDs recorded in Dolby Digital or DTS are played, Dolby Digital or DTS bitstream signals are output from the DVD player's digital audio
output connectors. If a Dolby Digital or DTS decoder is connected, you can achieve sound with the power and sense of presence of a movie
theater or concert hall.
DVD-5900
Front speaker (left)
Surround speaker (left)
NOTES:
• Harsh noise that could harm your ears or damage the speakers is generated when a DVD recorded in DTS is played while using a
decoder, etc., that is not DTS-compatible.
• When playing copyright-protected linear PCM or packed PCM DVDs, in consideration of copyrights, no digital signals are output for
sources exceeding 48 kHz/16 bits. When playing such sources, either set "LPCM (44.1 kHz/48 kHz)" under "AUDIO SETUP" at
"SETUP" to "ON" (see page 36) or make analog connections. (See page 14.)
• When making digital connections to an AV amplifier that is not compatible with 96 kHz/88.2 kHz signals, set "LPCM (44.1 kHz/48 kHz)"
under "AUDIO SETUP" at "SETUP" to "ON". (See page 36.)
• With Super audio CDs, digital audio signals cannot be output. Use analog connections. (See page 14, 15.)
2 Connecting an optical fiber cable (commercially available) to the digital audio input connector (OPTICAL)
Dust cap
Remove the dust cap, line up the cable in the proper directly, then
insert it securely as far as it goes.
12
75Ω/ohms pin-plug Optical fiber cable
(or)
cable (commercially (commercially
available) available)
Digital audio input Digital audio input
connector (COAXIAL) connector (OPTICAL)
AV amplifier with a built-in decoder
(AV control center)
Line up in proper direction
Center speaker
Front speaker (right)
Subwoofer
Surround speaker (right)
NOTE:
• Store the dust cap in a safe place, and be careful not to lose
it.
When not using the terminal, attach the cap to protect the
terminal from dust.
To power outlet