4.2.3
Column fixing
1. Fix the column to the cylinder tank by inserting
the pin with a hammer and tighten the fulcrum-pin
screw.
4.2.4
Put in place the vertical rod
1. Lower the locking lever to unlock the sliding rod (1).
2. Manually capsize rod backwards.
3. Unscrew the cap on top of the rod with a wrench
(2).
2
1
Robert Bosch GmbH
Initial commissioning | TCE 4335 | 27
!
Warning: when unlocking the rod keep a hand under-
neath it
4. Remove the rod; remove the spring and put again the
rod in its original seat, locking it at the end stop (1).
5. Insert the spring in the upper part of the rod and
screw again the cap with the wrench (2).
2
1
Danger!
The spring could eject violently the rod from
its housing, thus it might be a serious danger
for the operator.
Carry out this operation carefully.
en
|
1 695 106 642
2010-12-22