Electrical Connection; Check Rotation Direction; Operating Instructions; Tire Demounting - Bosch TCE 4335 Manual Del Usuario

4.4

Electrical connection

1. Check the correspondence of the mains tension and
the tension shown on the identification tag.
2. Ask a qualified electrician to mount a connection
plug for single-phase or (depending on the tension
you have ordered ) three-phase current (see the
electrical connections diagram inside the electrical
panel).
i
The costs of arranging a mains protection device for
the plug are borne by the customer.
3. Protect the TCE 4335 according to specific national
rules.
4.5

Check rotation direction

!
For a correct functioning of TCE 4335 it is extremely
important that, when the locking flange pedal shown
in Fig. 2 (1) is pressed, the locking flange (Fig. 2)
rotates clockwise.
Fig. 2: Check rotation direction.
Robert Bosch GmbH
1
Operating instructions | TCE 4335 | 31
5.

Operating instructions

Warning - tire or rim damage danger!
Excessive pressure can e. g. result in cracks
(on the inside/outside) of the tire. The rim
can be scratched or deformed.
€
Read the Wdk publications available in
German and English! (www.wdk.de: moun-
ting/demounting instructions – criteria
catalogue)
€
Inner temperature of the tire must be at
least 15 °C (only in case of RFT/UHP).
€
Read the Wdk publications available
in German and English! (www.wdk.de:
mounting/demounting instructions – tire
overheating)
€
Adjust pressure to the type of tire.
€
Use the plastic protections on the types of
rim that need it.
!
Before demounting or mounting operations it is ext-
remely important to collect all the rim and tire data.
In this way it will be possible to know in advance the
mounting, the pressure and the required accesso-
ries!
i
Remove all the balancing weights from the rim.
i
If the semi drop centre of the rim is placed in the
inside part it is necessary to insert a cover to the
locking jaws (see chap. 3.3) on the flanged plate,
because in this case the rim leans on its side during
rotation.
5.1

Tire demounting

i
Read the Wdk publications available in German and
English!
(www.wdk.de: mounting/demounting instructions).
5.1.1

Preparations for demounting

!
Avoid valve damage!
1. Pull out the needle from the valve.
« The air is discharged completely from the tire.
2. Place the wheel on the floor, close to the antiabrasi-
ve supports of the beadbreaker; to put the blade (1)
close to the bead pressing the bead breaker control
pedal (2). The operation has to be carried out in dif-
ferent points of the wheel (rotating it manually) until
the bead doesn't come off completely.
en
|
1 695 106 642 2010-12-22