Description Of The Menus - Palazzetti ECOFIRE IDRO Manual De Instalación, Uso Y Mantenimiento

11 DESCRIPTION OF THE MENUS

If a malfunction occurs, the following procedure is activated:
1) audible alarm (beep);
2) one of the following system LEDs come on:
3) if the problem concerns an error, the stove will switch off.
Pressing and holding the "cancel" button
ERROR/
WARNING CODE
E001
E002
E004
E101
E105
E106
E108
E109
E110
E111
A001
A002
A007
----
----
After having checked the type of message, the alarm can be reset by pressing the on/off button
moments.
Then the stove can be started again.
52/140
USE AND & MAINTENANCE
DESCRIPTION
Faulty control panel
Remote control signal communication
error
Communication error
Failed ignition error
Outlet water temperature too high
Temperature probe malfunction
Temperature probe malfunction
Safety error
Pressure error or thermal safety
Temperature probe malfunction
Flue gas temperature probe malfunction
Low pellet level
Scheduled maintenance warning
Pressure sensor malfunction
Clean stove
Failed ignition error
INSTALLATION MANUAL
;
shows the error code on the display:
POSSIBLE CAUSES
Control panel fault
Control panel fault
Connection cable between board and control panel
interrupted or detached.
error
No pellets
Pellet quality
Faulty ignition system
Burn pot dirty
Problems with the heating system
Problems with the pump
Faulty return water temperature probe
Faulty buffer tank temperature probe
Door or hopper lid open
Flue gas exhaust system dirty
Seal gaskets worn
Problems with the heating system
Problems with the pump
Problems with overheating in the pellet hopper
Faulty outlet water temperature probe
Faulty air temperature probe
Pellets running out
The stove periodically requires maintenance to be
Pressure sensor or board fault.
dirty.
Pressure measuring tubes detached or blocked.
Combustion air intake blocked.
No pellets; Faulty ignition heater; Worn gaskets; Incorrect
burn pot position
- cod. 004771060 - 09/2011 - Palazzetti - PN - Italy
Fig.11.1
LED
for a few