Identification Label; Delivery Of The Stove; Safety Warnings; Installation Warnings - Palazzetti INSERIMENTO A70 Manual De Instalación, Uso Y Mantenimiento

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

.

1.13 IDENTIFICATION LABEL

The serial number plate on the stove shows all the
typical product data, including the manufacturer's
details, the serial number and

1.14 DELIVERY OF THE STOVE

The stove is delivered packaged in a cardboard box
or shrink-wrap and secured to a wooden pallet for
handling by forklift and/or other equipment.
The following material is provided inside the stove:
installation, user and maintenance manual;
"product booklet" pertaining to the specific
model;
remote control (only on models where featured);
tool for opening of the firebox door (only on
models where featured).

2 SAFETY WARNINGS

2.1 INSTALLATION WARNINGS

Comply with the requirements specified in this manual.
The stove assembly and dismantling instructions are
reserved exclusively for specialist technicians.
Users should always contact our service centre to
request work to be performed by qualified technicians.
Before having work performed by other technical
personnel verify their effective technical competence.
Responsibility for work carried out in the place where
the stove is installed lies with the user; the user is also
responsible for making sure the installation checks are
completed.
The user must abide by all local, national and European
safety requirements.
The appliance must be installed on floors with a
suitable load-bearing capacity.
Make sure that the flue and air intake duct arrangements
correspond to the type of installation.
Do not make any electrical connections using
temporary or uninsulated cables.
Make sure the electrical system is earthed correctly.
Before starting to assemble or dismantle the stove, the
installer must heed the safety precautions required by
law, specifically:
A) do not work in adverse conditions;
B) always be in a fit mental-physical state for working
and make sure that personal protective equipment
is in perfect working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.

2.2 MAINTENANCE WARNINGS

Comply with the requirements specified in this
manual.
Use always personal protective equipment and
other means of protection.
Before starting any maintenance work make sure
that the stove, if it had been operating, has cooled
down.
28
INTRODUCTION
markings.

2.3 WARNINGS FOR THE USER

.
00 4776070 - 17/12/2018 - PN - Italy
If even just one of the safety devices is not
calibrated or not working, the stove must be
considered out-of-service.
Disconnect power before working on electrical or
electronic parts and connectors.
Prepare the stove installation site in accordance
with local, national and European regulations.
As the stove is a heating appliance it has very hot
outside surfaces. For this reason maximum care
must be paid during operation, specifically:
do not touch or get too close to the glass door to
avoid getting burned; do not look at the flame for a
long time
• do not touch the flue;
• do not perform any type of cleaning;
• do not remove the ash;
• do not open the glass door;
• do not open the ash bin (where featured);
• The unit can be used by children over the age of
8, and by people with reduced physical, sensory
or mental capabilities, or with no experience or
necessary knowledge, as long as they remain
under surveillance or after they have received
instructions on the safe use of the unit and have
understood the dangers involved. Children
must not play with the unit. The cleaning and
maintenance that must be performed by the
user must not be carried out by children without
supervision.
Non-specialised users must be protected from
access to any part that may expose him/her to
dangers. He/she must therefore not be allowed
to perform operations on internal parts at risk
(electrical or mechanical), not even it the electrical
power supply is disconnected
Comply with the requirements specified in this
manual.
Follow the instructions and warnings highlighted
on the metal labels affixed to the stove.
These labels are safety devices, therefore they
must always be perfectly legible. If damaged or
illegible they must be replaced, contacting the
manufacturer for an original spare label.
Only use fuel compliant with the specifications
shown in the corresponding chapter of this
manual.
Strictly follow the routine and special maintenance
plan.
Do not use the stove without first having performed
the daily inspection as specified in the chapter on
"Maintenance" in this manual.
Do not use the stove in the event of malfunctions,
suspected breakage or unusual noises.
Do not pour or spray water onto the stove when
operating or to extinguish the flame in the burn
pot.
Do not switch the stove off by unplugging the
power cord.
Tabla de contenido
loading

Este manual también es adecuado para:

Inserimento ac70

Tabla de contenido