Mafell K 55 Manual Del Usuario página 32

Defect
The machine switches off at a
sudden increase in load.
Saw blade jams as the machine is
advanced
Burn marks on the cut surfaces
Chip ejection blocked
Sudden smoke emission from the
motor casing
Cause
The sudden increase in load also
causes the current that is required
for the machine to rise. This rise
in current, which occurs when
there is a sudden blockage or
backlash, is measured and then
leads to the machine being
switched off.
Feed rate too fast
Blunt saw blade
Tension in the workpiece
Poor machine guidance
Uneven workpiece surface
The saw blade used is unsuitable
for the task or blunt
Wood is too damp
Extended operation
extraction
Overload of the
electronic system
-32-
Elimination
Switch off the machine by releasing
the switch trigger.
Afterwards, you can switch the
machine back on again and
resume work as normal.
Try to avoid further blockages.
Reduce feed speed
Release the switch immediately.
Remove the machine from the
workpiece and replace the saw
blade
Use parallel stop
Straighten the surface
Replace saw blade
without Connect machine to an external
extraction,
extractor
machine's Interrupt the power supply by
removing the battery pack. The
smoke emission stops.
Do not insert a rechargeable
battery!
smoke!
e.g. portable dust
Avoid inhaling the