Tabla de contenido
Idiomas disponibles
Idiomas disponibles
suitably qualified person or at the Customer
Service Centre.
J
Always work with the mains lead leading
away from the rear of the device.
J
If a dangerous situation arises, pull the mains
plug immediately out of the mains socket.
J
Always switch on the electrical power tool before
moving the workpiece against it. Otherwise
there is the risk of kickback.
J
Do not cut moist materials or damp surfaces,
J
Use only undamaged, defect-free saw blades
Distorted or blunt saw blades
cause a kickback.
J
Ensure that the teeth on the saw blade
downwards before you mount it in the device.
J
DANGER OF INJURY! Keep your hands
away from the area of the saw blade.
J
Before sawing, check the workpiece for foreign
bodies such as nails etc. and remove them. In-
jury and / or damage to property may result from
the saw blade striking nails etc. embedded in
the workpiece.
J
Always keep the device clean, dry and free
from oil or grease.
J
Switch off the device before you remove any
wood residue from around the saw blade.
Otherwise you could become injured.
WARNING!
HAZARDOUS DUSTS /
VAPOURS! Any noxious dusts or vapours
generated from sawing represent a risk to the
health of the person operating the device and
to anyone near the work area.
J
Do not saw materials containing substances
harmful to health.
J
Do not use the tool on materials containing
asbestos. Asbestos is a known carcinogen.
J
Make sure you have adequate ventilation.
J
Wear protective glasses, hearing
protection, dust protection masks
and protective gloves.
Advice on use
Q
J
Push the workpiece slowly and with minimum
pressure on to the saw blade.
J
Reduce the rate of advance when you are
cutting thicker material.
J
J
J
J
.
7
can break or
7
point
7
Q
Q
j
j
j
j
j
j
j
Safety advice / Assembly
Hold the workpiece firmly on the table with
both hands and push it slowly towards the saw
blade. Otherwise the saw blade may twist or
break.
Avoid making any sharp changes in direction
during sawing to prevent the saw blade from
twisting or tearing.
Before starting the saw cut, drill a hole at a
corner or internal cut-out in the workpiece and
start sawing from the hole.
Use the correct saw blade. The choice of saw
blade depends on the thickness and type of
material and the intended cut.
Select a saw blade with fine teeth to saw thin,
hard materials.
Use a narrow saw blade to saw small radius
cuts.
Assembly
WARNING!
DANGER OF INJURY!
Pull the mains plug out of the socket before you
carry out any task on the device,
Attaching the blade guard
(see Fig. A)
Push the screw
from the inside through the
10 c
slot in the blade guard
From the outside of the blade guard
the guide plate
on to the screw
10 b
The bent-up side of the guide plate
around the blade guard
Attach the blade guard
tachment arms
and insert the two screws
11
through the openings provided for them in the
attachment arms
.
11
Ensure that the upwardly curved end of the
blade guard
is at the top.
9
Put the plain washers
10 a
of the attachment arms
Screw the knurled nuts
ends
.
10 c
Slide the blade guard
tion and fix it in that position by tightening the
knurled nuts
.
10
9
.
9
, place
9
.
10 c
engages
10 b
.
9
between the two at-
9
10 c
on from the outside
.
11
on to the two screw
10
into the desired posi-
9
GB
17
Capítulos
Tabla de contenido
