Use - Drying - Electrolux EWW 127470 W Manual De Instrucciones

ager option, you must cancel the running
programme and make your selection again).
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to and then to the new pro-
gramme position. Start the new programme
by pressing the button 8 again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started and
through the delay time the door is locked. If
for any reason, you need to open it, set first-
ly the machine to PAUSE by pressing the
button 8 .
After a few seconds it will be possible to
open the door.
If the door remains locked, this means that
the machine is already heating or that the
water level is too high. In any case, do not
try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to O . After a
Stand by : once the programme has finish-
ed after a few minutes the energy saving sys-
tem will be enabled. The brightness of the

USE - DRYING

Drying only
Warning!
The recommended load size is 3.5 kg for
cottons and linen and 2 kg for synthetic
items.
By pressing Drying Time button it is al-
so possible to dry up to 5 kg of cotton
to cancel a pro-
few minutes the door can be opened (pay
attention to the water level and temper-
ature!) .
After closing the door, it is necessary to se-
lect the programme and options again and
to press button 8 .
At the end of the programme
The machine stops automatically. Three
blinking 0.00 appear on the display and the
pilot light of button 8 goes off. Some acous-
tic signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the wa-
ter must be emptied out before opening the
door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8 .
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to O to switch the ma-
chine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleas-
ant smells.
display is reduced. By pressing any button
the appliance will come out of the energy
saving status.
items (see the «Drying Programme » ta-
ble).
Warning!
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin
speed allowed for the type of laundry in
electrolux 75