Desktop Mounting; Wall Mounting - Mettler Toledo IND560 Guia De Instalacion

Desktop Mounting

When the IND560 terminal will be placed on a flat surface, the four rubber feet
included with the terminal should be adhered to the bottom of the enclosure to
prevent sliding. Locate the four rubber feet, remove the protective paper from the
adhesive, and press the feet onto the corners of the bottom of the enclosure as
shown in Figure 2-9.

Wall Mounting

There is an optional wall mounting bracket kit available for wall mounting the
IND560 harsh enclosure to a vertical surface. To wall mount the enclosure, follow
these steps:
1. Bolt the two brackets to the bottom of the enclosure using the four M5 screws
included with the terminal. The brackets should be attached as shown in
Figure 2-10.
Figure 2-10: Attaching the Wall-Mounting Brackets
2. If the enclosure will be mounted above eye level, proceed to step 4.
3. If the enclosure will be mounted at or below eye level, it will be necessary to
reverse the front cover 180 degrees. Note that reversing of the cover is not
possible with the PROFIBUS PLC interface installed. If the PROFIBUS option is
installed, proceed to step 4. To reverse the front cover, perform the following
steps:
IND560 Installation Manual
Figure 2-9: Rubber Feet
2-7