PIEROBON MIX 3B Manual De Instrucciones Y Repuestos página 46

Tabla de contenido
Para evitar que el metal se oxide y los alimentadores
se atasquen retirar toda la semilla (especialmente
si se ha tratado con productos químicos) y
el fertilizante antes de guardar la sembradora.
Familiarizarse con los procedimientos antes de
efectuar trabajos de mantenimiento.
No realice ningún trabajo de engrase, calibración
o reparación, con la máquina en movimiento.
Tenga cuidado de mantener manos, pies y ropa
lejos de los componentes móviles.
3) Nivelación del balancín hidráulico
1) Colocar la sembradora en un lugar lo más parejo posible.
2) Descomprimir el circuito hidráulico.
3) Girar la válvula General
Nivelación Balancín.
4) Abrir las 2 llaves esféricas
5) Hacer nivelar el balancín hasta que ambos paralelo-
gramos se encuentren en forma horizontal. Si la sembra-
dora se encuentra sobre algún desnivel, controlar que la
parte visible de los vástagos de ambos cilindros hidráuli-
cos del balancín sumen un total de 150 mm. (Ejemplo:
70 mm +
80 mm = 150 mm)
(Figura 60)
(Figura 61)
6) Cerrar las dos llaves esféricas.
7) Girar la válvula general a la posición Levante Simple
de Trabajo.
Válvula general
General valve
Nivelación balancín
Rocking system
adjustment
Levante simple de trabajo
Simple raised working position
Figura / Picture 58
a la posición de
(Figura 58)
(Figura 59).
Válvulas esféricas
Ball valves
Abierto
Open
Cerrado
Closed
Figura / Picture 59
To avoid metal getting rusty and meters getting
clogged, remove seeds (especially if they have
been chemically treated) and fertilizer completely
before storing the machine.
Understand all procedures before doing
maintenance jobs.
Never lubricate, adjust or repair machine while
it is in motion.
Keep hands, feet and clothing away from
moving parts.
WARNING
WHEN CLEANING BOXES
Do not use water.
Clean them with a brush
or compressed air.
Hydraulic rocking system adjustment:
1) Keep the machine on even, steady ground.
2) Decompress the hydraulic circuit
3) Turn the General valve
lic rocking system adjustment
4) Open both ball valves
5) Adjust the rocking system till both parallel arms meet
horizontally. If the machine is on a slope, make sure that
rods visible part in both rocking system hydraulic
cylinders make a total of 150 mm. (Example:
70mm +
80 mm = 150 mm)
(Picture 61)
6) Close both ball valves.
7) Turn the general valve to simple raised working
position
70 mm
Figura / Picture 60
45
I-8813
to the position hydrau-
(Picture 58)
.
(Picture 59)
(Picture 60)
80 mm
Figura / Picture 61
Tabla de contenido
loading

Productos relacionados para PIEROBON MIX 3B

Tabla de contenido