Time Dry And No Heat Modes - Alliance Laundry Systems T433I Operación / Mantenimiento / Programación

Programming the Electronic OPL Control

Time Dry and No Heat Modes

After fabric selection, press the TIME pad. Refer to
Figure 14.
MORE
+
TIME DRY PADS
Figure 14
A preset drying time, "Td:**" will replace "A0:00" in
the display. This time can be changed by pressing the
MORE or LESS pads. For 1 minute changes, press pad
and release. For 5 minute changes, press pad and hold.
Maximum drying time allowed is 60 minutes. Refer to
Table 3 for Preset Drying Times.
Cycles Preset Time
HIGH
MEDIUM
MED LOW
LOW
NO HEAT
Table 3
22
TIME
COOL
DOWN
LESS
- -
T397I
Range
35 Min. 1 – 60 Min.
20 Min. 1 – 60 Min.
15 Min. 1 – 60 Min.
30 Min. 1 – 60 Min.
20 Min. 1 – 60 Min.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
"AC:**" will be displayed when tumbler is in Auto
Cool Down. Typical cool down times for fabric
selections are preset as shown in Table 3. The cool
down time can only be altered before cycle is started.
To alter cool down time press the COOL DOWN pad
and then press the MORE or LESS pad (when cool
down time is altered, "TC:**" will be displayed). For 1
minute changes, press pad and release. For 5 minute
changes, press pad and hold. Cooling time can be from
1 to 39 minutes. To return to the Auto Cool Down,
press MORE or LESS pad until "AC:**" is displayed.
To start the cycle, press START. The total drying time
plus cool down time will display. During the cycle,
remaining time displays.
NO HEAT is a time dry cycle only. When NO HEAT is
pressed, a 20 minute preset time will display. This can
be changed from 1 minute to 60 minutes by pressing
the MORE or LESS pads before pressing START. The
COOL DOWN pad does not work in NO HEAT
cycles.
T397I
M414462