Electro-Mechanical Coin Control Tumbler - Alliance Laundry Systems T433I Operación / Mantenimiento / Programación

PUSH TO START
BUTTON

Electro-Mechanical Coin Control Tumbler

1. Set the TEMPERATURE selector at HIGH or
LOW, or anywhere between these settings.
2. Coin Drop Models: Insert the coin(s) in the coin
slot, turn the knob to the right and release it.
Coin Slide Models: Insert the required number of
coins in the coin slide. Push coin slide in
completely and then release it.
3. Press the PUSH TO START button and hold it for
approximately three (3) seconds.
IMPORTANT: If the cylinder door is opened
during the cycle, the heating system will shut off
and the motor will stop. However, the timer will
continue to run. To restart the cycle, the door must
be closed and the PUSH TO START button must be
pressed in.
M414462
TEMPERATURE SELECTOR
TEMPERATURE
HIGH
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
METER COIN SLOT AND KNOB
LOW
INSERT QUARTER
TURN KNOB
PUSH
TO
START
1
SELECT
TEMP
Figure 3
To reduce the risk of bodily injury, the
tumbler stops tumbling when the door is
opened. Do not use the tumbler if it does
not stop tumbling when the door is opened
or starts tumbling without pressing the
START pad. Remove the tumbler from use
and call for service.
4. When the cycle is complete, open door and
remove the laundry.
Operating Instructions
SINGLE AND DUAL COIN
25
2 3
INSERT PUSH
COIN START
WARNING
T366I
W078
13