Heat Source Check; Electric Dryers; Gas Dryers - Alliance Laundry Systems D009C Instalación/Operación

Heat Source Check

Electric Dryers

Metered Models
Set the proper FABRIC SELECTOR switch at
NORMAL. Place coins in the slide and carefully push
slide in as far as possible. IN USE light will come on
indicating the dryer is ready to operate. Close the
loading door and press the PUSH-TO-START button
firmly to start the dryer. After either dryer has operated
for three minutes, the exhaust air or exhaust pipe
should be warm.
Nonmetered Models
Set FABRIC SELECTOR switch at NORMAL and
turn timer knob to 50. Close the loading door and press
the PUSH-TO-START button. IN USE light will come
on indicating start of cycle. After either dryer has
operated for three minutes, the exhaust air or exhaust
pipe should be warm.

Gas Dryers

During the gas heat check, observe the burner flame.
The flame can be viewed by removing the lower front
panel of the dryer.
Metered Models
Set FABRIC SELECTOR switch at NORMAL. Place
coins in the slide and carefully push slide in as far as
possible. IN USE light will come on indicating the
dryer is ready to operate. Close the loading door and
press the PUSH-TO-START button firmly. The dryer
will start, the igniter will glow red and the main burner
will ignite.
510975 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Nonmetered Models
Set FABRIC SELECTOR switch at NORMAL and
turn timer knob to 50. Close the loading door and press
the PUSH-TO-START button. IN USE light will come
on indicating start of cycle, the igniter will glow red
and the main burner will ignite.
IMPORTANT: If all air is not purged out of the gas
line, the gas igniter may go off before the gas is
ignited. If this happens, after approximately
two minutes the igniter will again attempt gas
ignition.
All Models
After either dryer has operated for approximately
five minutes, observe burner flame. Adjust the air
shutter to obtain a soft, uniform blue flame. (A lazy
yellow-tipped flame indicates lack of air. A harsh,
roaring, very blue flame indicates too much air.)
Adjust the air shutter as follows:
1. Loosen the air shutter lockscrew.
2. Turn the air shutter to the left to get a luminous
yellow-tipped flame, then turn it back slowly to
the right to obtain a steady soft blue flame.
3. After the air shutter is adjusted for proper flame,
tighten the air shutter lockscrew securely.
4. Reinstall the lower front panel.
WARNING
For personal safety, lower front panel
must be in place during normal operation.
After either dryer has operated for approximately
three minutes, the exhaust air or exhaust pipe should be
warm.
Installation
W046
19