Electronic Opl Control - Alliance Laundry Systems T433I Operación / Mantenimiento / Programación

Operating Instructions

Electronic OPL Control

1. To use an Automatic Cycle, press an ON/
SELECT pad. Select HIGH, MEDIUM,
MED LOW, LOW or NO HEAT for items that
should not be dried with heat. A light to the left
of the selected pad lights up.
To use a Time Dry or Custom Cycle, refer to
section Programming the Electronic OPL
Control.
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to Figure 7.
Figure 7
16
ON / SELECT
HIGH
START
MEDIUM
STOP/RESET
TEMP
MED LOW
DISPLAY
F/ C
LOW SIGNAL
NO HEAT
REVERSING
T306I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
STATUS PROGRAM
AUTO
DRYING
AUTO
SPECIAL
COOL DOWN
CYCLE
*
AUTO
TEMP
DOOR OPEN
CUSTOM
MORE
+
CONDITION
Figure 6
2. Press START pad to start tumbler.
NOTE: All pads can be pressed in any sequence
without damaging control or tumbler. To stop the
tumbler at any time, open the door or press STOP/
RESET. The window display will flash. Press
STOP/RESET twice (within 3 seconds) to end the
cycle and reset the control to idle status. To restart
the tumbler, CLOSE door and press START pad.
To reduce the risk of bodily injury, the
tumbler stops tumbling when the door is
opened. Do not use the tumbler if it does
not stop tumbling when the door is opened
or starts tumbling without pressing the
START pad. Remove the tumbler from use
and call for service.
3. When the cycle is complete, open door and
remove the laundry.
TIME
SPECIAL
TIME
*
COOL
DOWN
LESS
- -
SAVE
CUSTOM
PROG
T359I
WARNING
T359I
W078
M414462