Waring Commercial MX Serie Manual De Operación página 6

door is removable for cleaning. To clean, wipe with damp cloth. Not for
waterjet cleaning.
To remove sound enclosure door, follow these steps:
1. Open sound enclosure and remove blender container.
2. Close door.
3. Grasp sides at pivot boss and separate to remove door.
4. To clean door, wipe with a damp cloth. Not for waterjet cleaning
NOTE: Remove rubber jar pad to clean underneath.
To replace sound enclosure door, follow these steps:
1. Replace rubber jar pad.
2. Replace door at pivot boss and attach to secure door.
3. Insert blender container and close sound enclosure.
MX ELECTRONIC TOUCH PAD SWITCHES WITH TIMER
1. Before starting, make sure that the blender is
unplugged.
2. With the unit in "OFF" position, place container on
blender base. Be sure container is fully seated and
that drive coupling is properly engaged. Plug blender
cord into outlet.
3. Put ingredients into container and cover it. Do not fill above MAX line.
4. This blender is equipped with an electronic membrane keypad. The key-
pad has a main power ON/OFF
PULSE
DOWN
5. Press the ON/OFF
nate. The electronic timer will indicate 10 seconds (default). Press the
UP or DOWN
indicate run time in 5-second intervals up to a maximum of 30 seconds.
After the desired time is set, press HI
timer will count down to 0 in 1-second intervals and blender will shut off.
Pressing the PULSE
button will override the timer and the blender will stop regardless of time
left on timer.
NOTE: If you want to increase or decrease time while timer is counting
down, press UP
5-second intervals.
6. If the blender is not used for five seconds, the timer function will turn "Off"
and return to manual mode. To reactivate timer, press UP
arrows. When using the electronic timer again, the initial time will be the
last time set. Note: If unit has been turned off or unplugged, the timer will
default back to 10 seconds.
7. For continuous operation, press either LO
blending, press STOP
button. Motor will run on HI
NOTE: Your MX Electronic Blender utilizes a Slow Start
pressing HI
buttons and a 30 second count down timer with UP
arrows to set time.
button to turn on the blender. Green LED will illumi-
arrow to set the desired time. The electronic timer will
button, the STOP
or DOWN
. For momentary operation, press the PULSE
, the unit will start in the LO
button, plus HI
or LO
button or the ON/OFF
arrows. Time will increase or decrease in
or HI
speed until the button is released.
speed for 2 seconds and then
5
, LO , STOP
to start the blender. The
or DOWN
button. When finished
feature. When
™
and
and