Waring Commercial MX Serie Manual De Operación página 4

1. Before starting, make sure that the blender
is unplugged.
2. With the unit in "OFF"
blender base. Be sure container is fully seated and
that drive coupling is properly engaged. Plug blender
cord into outlet.
3. Put ingredients into container and cover it. Do not fill
above MAX line.
4. This blender has 2 speed settings: HI
to desired position. To crush ice quickly, use HI
5. When finished blending, set paddle switch to "OFF"
6. This blender is equipped with a PULSE
"Down" position to engage PULSE
until the paddle switch is released.
7. Allow motor to come to a complete stop before removing container from
blender base. Never place the container on the motor base or remove it
from the motor base while motor is running.
8. Always hold container with one hand when starting and while blending.
Never operate without jar lid.
9. Wash and dry container after each use. See Cleaning and Sanitizing
instructions.
NOTE: If you have an electronic unit, please refer to the following instructions.
WITHOUT SOUND ENCLOSURE AND INTERLOCK
1. Before starting, make sure that the blender is unplugged.
2. Place container on blender base. Be sure container
is fully seated and that drive coupling is properly
engaged. Plug blender cord into outlet.
3. Put ingredients into container and cover it. Do not fill
above MAX line.
4. This blender is equipped with an electronic
membrane keypad. The keypad has a main power
ON/OFF
5. Press the ON/OFF
illuminate. For continuous operation, press either LO
When finished blending, press STOP
press the PULSE
is released.
NOTE: Your MX Electronic Blender utilizes a Slow Start
pressing HI
then switch to HI
ingredients in container.
MX MECHANICAL SWITCHES
position, place container on
MX ELECTRONIC TOUCH PAD SWITCHES
button, and HI
button to turn on the blender. Green LED will
button; motor will run on HI
, the unit will start in the "Low" speed for 2 seconds and
speed. This allows for a more even blending of
and LO . Press Paddle Switch
option. Hold paddle switch in
function. Unit will run on HI
and LO , STOP
. For momentary operation,
3
speed setting.
position.
and PULSE
or HI button.
speed until the button
feature. When
™
speed
buttons.