Changing The Oil - TRAPP JK-500 Manual De Instrucciones

The first oil change must be conducted in the first 5
hours of motor use. To change the oil, proceed as
follows:
1. Place the crusher on a leveled and flat surface.
2. Hot oil will drain better.
3. Collect used oil in proper container and wear
appropriate glasses and globes during the oil
change.
4. Open the oil drainage plug (1) so as to drain the oil
from the engine. Remove the oil inspection cap (2)
to facilitate the drainage of all the motor oil.
Attention!
If motor is hot when changing oil, be

careful to remove oil container. Hot
oil is released with more pressure, and
may cause burns.
Do not place oil containers or

discarded motor oil into common
waste bins or on the soil, follow the oil
manufacturer's instruction to correctly
discard it.
5. When oil has been fully drained, screw back oil
container (1).
6. Remove the cap (2) and add the required amount
of oil and, then, close the cap (2).
56

Changing the Oil

7. Check the oil level with the inspection cap (2). For
a precise reading, with the motor leveled, check if
the oil reached the bottom of the thread where the
inspection cap is threaded, this is the correct level.
Note:

1
Image for illustration purposes only
Frequently check level of motor oil to
prevent damage due to lack of oil.
www.trapp.com.br
2