Access To The Blades - Electric And Gasoline - TRAPP TRC-40 Manual De Instrucciones

7
5
6
8
Image merely illustrative.

Access to the Blades - Electric and Gasoline

1
2
42
Main Components - TRC-50
1
3
2
4
5
3
4
Image merely illustrative.
1. Feeding funnel
2. Belt stretcher hand wheel
3. Counter-nut the belt tensioner
4. Wheel
5. Handle to open the feeder
6. Material outlet spout
7. Gasoline engine
8. Rubber cushion
To have access to the blades, proceed as described
below:
Loosen the handle (1), contact washer (2),
 
spring washer (3) and flat washer (4).
Now pivot the feeding funnel (5) to access the
 
maintenance of the blades.
TRAPP shredders leave factory with temperate
cutting blades prolonging cutting durability.
Sharpen the cutting blades when the edge is dull.
Whenever sharpening, be careful to remove the
same amount of material from each cutting blade to
keep balance and to avoid vibrations of the axle unit.
The cutting blades shall be substituted whenever
optimum sharpening is no longer possible.
You will notice that the blades have sharp ends
on one side only; sharpen the blades in the
same direction, location and angle according
to the blade model, and following the same
conditions.
www.trapp.com.br