Technical Description (Component And Interfaces) - Dentsply Sirona inLab MC X5 Instrucciones De Uso

Dentsply Sirona
Operating Instructions Suction devices for inLab MC X5 and
64 98 609 D3608
D3608.201.02.04.02 09.2017
CEREC MC/MC X/MC XL Premium Package 230 V (REF 6569730)
suction device:
● 230 V suction device
● Filter bag (installed)
● HEPA filter (installed)
● Suction tube, complete
● Interface cable
● Operating Instructions
● Power cable
CEREC MC/MC X/MC XL Premium Package 120 V (REF 6569748)
suction device:
● 120 V suction device
● Filter bag (installed)
● HEPA filter (installed)
● Suction tube, complete
● Interface cable
● Operating Instructions
● Power cable
3.3

Technical description (component and interfaces)

The suction devices are intended for operation on the inLab MC X5 or on
the CEREC MC/MC X/MC XL Premium Package milling units. The
suction system is equipped with a special filter bag and a HEPA micro
filter of filter category H12, which filters fine dust up to 99.5% and is
classified as fine dust category M.
A Socket for suction tube
B Control panel
C Maintenance flap
D Socket for interface cable
Check the device for any transport damage immediately after unpacking.
If there is transport damage, raise this with your supplier immediately.
3 General information on the device
E On/Off switch
F Socket for power cable
G Suction power control
H Device safety switch
11