Machine Assembly - GGP ITALY BS 35 Manual De Instrucciones

6
EN

4. MACHINE ASSEMBLY

IMPORTANT
some of the components disassembled and the
fuel tank empty.
WARNING!
gloves to handle the cutting devices. Mount
the components very carefully so as not to
impair the safety and efficiency of the ma-
chine. If in doubt, contact your dealer.
1. COMPLETING THE MACHINE
1a. "MONO" models (Fig. 1)
WARNING!
(1) is to ensure a minimum distance between
the rear handgrip and the front one, for safety
reasons. This spacer must always be fitted
and must not be modified in any way.
– In front of the spacer (1), fit the sleeve (2) and the
lower part (3) with guard.
– Fit the front handgrip (4) by using the screws (5).
– Before tightening the screws (4), align the hand-
grip correctly with respect to the drive tube.
– Fully tighten the screws (4).
1b. "DUPLEX" models (Fig. 2)
– Put the handlebar (1) into the seating in the sup-
port (2), located on the drive tube (3), making
sure that the controls are on the right.
– Fit the cap (4), fully tightening the screws (5).
The support (2) is already preassembled on the
transmission tube; this position must never be
changed.
2. FITTING THE GUARDS
WARNING!
provided with a specific guard. Never use
guards other than those indicated for each
cutting device.
The machine is supplied with
Always wear strong work
The purpose of the spacer
Each cutting device is
• 3 point blade (Fig. 3)
WARNING!
and fit the blade guard.
– Remove the blade (if fitted) as described in para-
graph 4.
– The guard (1) is fixed to the angle transmission
(2) by four screws (3).
• Cutting line head (Fig. 4)
WARNING!
line head the additional guard, with line cutting
knife, must always be fitted.
– Remove the blade (if fitted) as described in para-
graph 4.
– The guard (1) is fixed to the angle transmission
(2) by four screws (3).
– Secure the additional guard (4) using the screw
(5).
3. REMOVING AND REFITTING
THE CUTTING DEVICES
WARNING!
devices or ones homologated by the Manu-
facturer.
• 3 point blade (Fig. 5)
WARNING!
and fit the blade guard.
NOTE
left-hand thread and so must be unscrewed in a
clockwise direction and screwed up anticlockwise.
– Insert the wrench supplied (2) into the specific
hole in the angle transmission (3) and rotate the
blade (1) by hand until the wrench enters the in-
ner hole, blocking rotation.
– Unscrew the nut (4) clockwise.
– Take off the cap (5) and outer ring (6), then re-
move the blade (1), taking care not to take off the
inner ring (7) and spacer (8).
MACHINE ASSEMBLY
Wear protective gloves
When using the cutting
Use only original cutting
Wear protective gloves
The fastening nut (5) has a