Figure 11
Page
-32-
How To Operate The Machine
How to Operate the i-Drive Controls
The following controls are located on the joystick:
A
1.
B
2.
C
3.
Horn Operation
The horn is a continuous tone when pressing the horn button. In
reverse the horn pulses automatically.
One Touch Operation
One touch cleaning is a feature on the new Focus Rider Scrubber.
The factory defaults for this setting are two bars of brush pressure
and four bars for solution flow and squeegee in the down position.
1.
2.
3.
4.
5.
NOTE: It is intended that this be done while traversing. If you
stop and do it, some solution can be left on the floor.
Reprogramming One Touch
If you do not want to use the factory default settings, you may
reprogram the setting by following the procedures below:
1.
2.
3.
Horn : The horn is a red button located on the top of the
joystick (figure 11, item A). NOTE: The horn sounds
continuously when pressed and intermittent and
automatic in reverse.
One Touch: The one touch button is a green button located
on the upper front of the joystick (figure 11, item B). NOTE:
For more information about the one touch control see
below.
Speed Selector: The speed selector is a black button
located on the lower front of the joystick (figure 11, item C).
Press and release the green button for all cleaning
functions to begin.
The squeegee and brush head lower to the floor and the
vacuum starts.
The brushes and solution will begin only when you begin to
traverse.
The cleaning will be at the factory default settings, however
you can reprogram these settings to your specifications.
See "Reprogramming One Touch" section below.
To end cleaning process, press the green button again and
solution will stop; brushes will raise; after a short delay
squeegee will raise; and the motor will turn off.
Place the machine in the desired scrub condition by using
the one touch and individual switches.
Press and hold the green one touch button until you hear a
single beep from the machine then release the button.
NOTE: The time required should be approximately 5
seconds.
When you activate or deactivate the one touch, it will now be
set to your preference for cleaning. These settings will
remain until you disconnect power or reprogram them.
NOTE: When programming one touch, be sure squeegee
is in automatic (middle) position, otherwise you may
program squeegee either up or down all the time.
®
Clarke
Operator's Manual -Focus Rider Scrubber
EN