Dc Current Measurement (503 Only) - AEMC Instruments 501 Manual De Instrucciones

4.5 DC Current Measurement
NOTE: Remove the test leads before measuring current
• Turn the rotary range switch to the
• If needed, the display may be "zeroed". Press the
ZERO button to zero the reading. Note that the meter
enters the 40A manual range mode when zeroed. If
the measured current is greater than 40A (OL dis-
played), the user needs to manually select the 400A
range (see Manual Range procedure § 4.1.2), and
then zero the probe again.
• Press the lever to open the jaws.
• Clamp the jaws around the conductor to be measured.
• If reading is unstable and is hard to read, push the
HOLD button and read the measurement.
WARNING: Immediately unclamp the meter
from the conductor under test if overload "
is displayed.
Clamp-on Meter Models 501 and 503
(503 only)
range.
"
17