Operation; Locking The Wheel - SICE S 560 Manual De Instrucciones

If the pressure value is not within the above indicate range see the "MAINTENANCE" of this manual to solve this
problem.
If the pressure shown in the manometer, is still not within this range, DO NOT USE the tyre changer and call your
nearest Assistance Centre.
DANGER! During all operations, keep hands and other parts of the body as far as possible from moving parts of
the machine.
Necklaces, bracelets and too large clothes, can be dangerous for the operator.
WARNING!
In locking the wheel, make sure that clamps are properly positioned on the rim, so as to prevent the tyre from
falling.
1) Take the mobile control unit to work position B.
2) Pull the tool-holder arm (14, fig. D) into the upright position.
3) Move the top joystick and move the turntable leftwards thus creating enough space for the wheel to be mounted on the platform.
Keep the wheel in vertical position.
DANGER!
This operation can be extremely
dangerous.
Do it manually only if you are certain
you can keep the wheel balanced.
For large and heavy tyres an adequate
lifting device must be used.
4) Continuing to operate from the mobile control centre,
lift or lower the arm in order centre the self-centering chuck
(3, fig. A) relative to the rim.
5) With the clamps (22, fig. A) in the closed position, move
the turntable near the wheel, then operate the switch (9,
fig. C) to open the turntable, thus locking the rim internally
and in the most appropriate position to be chosen according
to the type of rim, as explained in figures E/1-E/2-E/3-
E/4-E/5-E/6.
Always remember that the safest locking is on the
central flange.
N.B. for rims with channel, clamp the wheel so that the
channel is near the outside of the rim (fig. E/1).
DANGER!
Do not very the work area with a
wheel clamped on the tyre changer
and lifted up from the floor.
S 560

12. OPERATION

12.1 LOCKING THE WHEEL

42
ENGLISH • Instructions manual
E/1
E/3
E/5
E/2
E/4
E/6