Bosch GRL250HV Instrucciones De Funcionamiento Y Seguridad página 20

The numbering of the product features refers
to the illustrations on the remote control
graphics page 18.
1A Button for rotational operation and
selection of the rotation speed
2A Button for line operation and line length
selection
3A Shock-warning reset button
4A Button for "rotation in clockwise
direction"
Initial Operation
• Protect the remote control against
moisture and direct sunlight.
• Do not subject the remote control to
extreme temperatures or variations in
temperature. As an example, do not
leave it in vehicles for longer periods. In
case of large variations in temperature,
allow the remote control to adjust to the
ambient temperature before putting it
into operation.
The remote control remains ready for
operation as long as a battery with sufficient
voltage is inserted.
For detailed information of the rotational
laser functions, see the operating instructions
of the rotational laser.
Rotational Operation
(150/300/600 min-1)
The function of the button for rotational
operation 1A on the remote control is
identical with that on the rotational laser.
Each time after switching on, the rotational
laser is in rotational operation mode with
average rotational speed.
To switch from line operation to rotational
operation, press the rotational operation
button 1A. Rotational operation starts with
average rotational speed.
To change the rotational speed, press the
rotational operation button 1A again until the
requested speed is reached.
RC1 Features
10A Serial number
The accessories illustrated or described
are not included as standard delivery.
RC1 Operation
Set up the rotational laser in such a manner
that the signals of the remote control directly
reach one of the reception lenses on the
rotational laser (for this, see the operating
instructions of the rotational laser). When the
remote control cannot be pointed directly
against a reception lens, the working range is
reduced. By reflecting the signal (e.g. against
walls), the working range can be improved,
even for indirect signals.
After pressing a button on the remote control,
the illuminated operation indicator 6A
indicates that a signal was sent out.
Switching the rotational laser on/off with the
remote control is not possible.
RC1 Operating Modes
The function of the button for line operation
2A on the remote control is identical with that
on the rotational laser.
To switch to line or point operation, press the
line operation button 2A. The rotational laser
switches to line operation with the smallest
aperture angle.
To change the aperture angle, press the line
operation button 2A. The aperture angle is
increased in two steps; at the same time, the
rotational speed is increased with each step.
When pressing the line operation button 2A a
third time, the rotational laser switches to
point operation after brief post-pulsation.
Pressing button 2A again takes you back to
line operation with the smallest
aperture angle.
-20-
5A Button for "rotation in anticlockwise
direction"
6A Operation indicator
7A Outlet opening for infra-red beam
8A Battery lid
9A Latch of battery lid
Line Operation, Point Operation
(10°/25°/50°, 0°)