Connect Battery Charger To The Product; Display Of The Current Charge Level; Display Of Battery Charge Level Without Additional Devices - Ottobock C-Brace 17KO1 Serie Instrucciones De Uso

6.2 Connect battery charger to the product

INFORMATION
After disconnecting the battery charger, the orthosis is in the same state it was in before con­
necting the battery charger. For example, if the orthosis was switched off before connecting the
battery charger, it will also be switched off after disconnecting the battery charger. A descend­
ing sequence of beeps is emitted when the battery charger is disconnected while the orthosis is
switched off .
INFORMATION
No display after connecting the battery charger
If no symbols light up on the control panel after connecting the battery charger, the battery may
be deep discharged. Leave the battery charger connected for at least 15 minutes and check the
charge level while charging by pressing the

6.3 Display of the current charge level

6.3.1 Display of battery charge level without additional devices

The current charge level of the installed battery can be displayed by briefly pressing the
ton:
Symbol Battery charge level
Charge level 67% to 100%
Charge level 34% to 67%
Charge level 10% to 34%
Charge level 5% to 10%
Charge level 1% to 5%
70
1) Open the charging receptacle cover.
2) Connect the charging plug to the charging receptacle of the
product.
INFORMATION: Take note of the plug direction!
→ After the displays are tested, a short beep is emitted followed by
three short vibration signals.
→ If the symbol lights up, this means an error was identified
during the self-test (see Page 92).
3) The charging process starts.
→ To check the charge level while the battery charger is connec­
ted, briefly press the
4) Disconnect the product after the charging process is complete.
→ After disconnecting the battery charger, a vibration signal is
emitted followed by a short beep, and the current status is dis­
played for approx. 5 seconds (see Page 92).
→ When the symbol in the
is switched on and ready for operation.
5) Close the charging receptacle cover.
button on the control panel.
button is lit up green
button.
, the product
but­