Start-Up; Operation; Pauses During Work; Mixer Cleaning And Shutdown - WAGNER PlastMix 15 Manual De Instrucciones

PlastMix 15
5

START-UP

During work start and stop the mixer ex-
clusively by means of the ON/OFF buttons.
Put the bag with the dry material on to the bag opener. Raise
both ends of the bag and tip the contents into the funnel (fig. 7).
Do not pour any water or damp materials into the funnel.

At this point position a suitable container below the material
outlet and start up the mixer by means of the ON/OFF switch. The machine should now be in operation
To obtain the required material consistency:
Optimise the quantity of the water delivered by means of the
valve, while the mixer is in operation.
Start with a higher rate of water in order to avoid any blockages.
Next, reduce the water rate as required.
The machine is fitted with protection against power failure: if
this occurs, press the ON button to resume operation.
In an emergency, interrupt the operating
of the machine by pressing the red ON/OFF
switch. This causes all moving parts to stop.
Next, disconnect the plug.
The electric motor is protected against over-
load by a thermal cutout. The mixer has to
be switched back on again via the ON/OFF
switch once it has cooled down.
6

OPERATION

The hopper safety grid must always be
fitted.
Wear envisaged personal protection devices
before starting work.
6.1

PAUSES DURING WORK

During breaks in work, be aware of the pot life of the material
in order to avoid blockages.
If no material exits the discharge outlet, this must be cleaned.
Stop the machine, proceed as described in para. 7, refit and
restart the unit.
7
MIXER CLEANING AND
SHUTDOWN
Caution! Before disassembling the mixer
or removing the grid, ensure that the main
switch is set to OFF and the plug is discon-
nected from the power supply.
Remove the mixing chamber (fig. 8, ref.1) by turning it to release
the relative hooks (ref.2), together with the shaft (ref.3).

2
3
1
Clean and dry the mixing chamber and agitator. Refit the shaft
in its seat after ensuring that it is clean, then insert the mixing
chamber and hook up correctly.
After cleaning the machine, open the drain tap on the water
GB
21