Getting Started; Accessory List; Location Of Controls - Alpine IVA-D106 Manual De Operación

Getting Started

Accessory List

• Head unit .............................................................................1
• Power Cable ........................................................................1
• Pre OUT/AUX cable.............................................................1
• iPod Video FULL SPEED™ Connection Cable ....................1
• Mounting Sleeve ..................................................................1
• Mounting Bracket ................................................................2
• Flush Head screw (M4 x 3)..................................................8
• Hexagon washer-head screw (M4 x 6)................................4
• Front Frame .........................................................................1
• Remote Control....................................................................1
• Battery (CR2025).................................................................1
• Carrying bag .......................................................................1
• Owner's Manual .............................................................1 set
Connectable to Remote Control Interface Box
You can operate this unit from the vehicle's control unit when an
Alpine Remote Control Interface Box (optional) is connected. For
details, contact your Alpine dealer.

Location of Controls

Rotary encoder/MUTE/AUDIO
Adjust the volume by turning to the left or right.
Press the Mute mode on or off by pressing repeatedly.
If pressed and held for at least 2 seconds, the audio setup
screen is displayed.
SOURCE/ button
Turns the power on. Press and hold for at least 2 seconds to
turn the power off.
Monitor open: Recalls the SOURCE selection screen.
Monitor closed: Changes the source.
10
-EN
BAND/SAT button
Radio mode: Changes the band.
Visual source (except navigation screen): Changes the
display mode.
Press this button for at least 2 seconds to recall a weather
channel or traffic channel. Note however, this setting can be
made only if the XM or SIRIUS Receiver Box is connected.
Remote Sensor
Point the supplied remote control transmitter towards the
remote sensor within a range of 2 meters.
VISUAL button
Press and hold for at least 2 seconds to recall the VISUAL
selection screen.
If VISUAL is set in "Setting the VISUAL Button" (page 39),
momentarily press to recall the VISUAL selection screen,
and if NAV. is set, momentarily press to recall the navigation
screen.
OPEN/CLOSE/FLAT button
Opens the monitor.
Closes the monitor by pressing and holding for at least 2
seconds.
Press to set the open monitor to the flat position.
button
Ejects a disc.
button
Use this button to remove the front panel.
DISC IN Indicator
Lights up when a disc is inserted in the unit.
Power Indicator
This indicator is lit when power is on.
• The buttons on the face of this unit are shown in bold (e.g.
SOURCE/ ). The onscreen buttons that appear in the display
are shown in bold enclosed by [ ] (e.g. [BAND]).